A simple model of EMI-induced timing jitter in digital circuits, its statistical distribution and its effect on circuit performance

A simple model has been developed to characterize electromagnetic interference induced timing variations (jitter) in digital circuits. The model is based on measurable switching parameters of logic gates, and requires no knowledge of the internal workings of a device. It correctly predicts not only the dependence of jitter on the amplitude, modulation depth and frequency of the interfering signal, but also its statistical distribution. The model has been used to calculate the immunity level and bit error rate of a synchronous digital circuit subjected to radio frequency interference, and to compare the electromagnetic compatibility performance of fast and slow logic devices in such a circuit

Electromagnetic Monitoring of Semiconductor Ageing

AbstractThis paper reports on the outcomes of the project “Electromagnetic Monitoring of Semiconductor Ageing” funded through the EPSRC Centre for Innovative Manufacturing in Through-life Engineering Services. The basis of the feasibility study reported in this paper is that all active devices exhibit non-linear behaviour and the behaviour of those devices will change as they age. As a result, the radiation or re-radiation of intermodulation products will change as the device ages. The goal of the project is to verify that this change in non-linear behaviour could be identified in a way that does not require modification of existing circuitry, thus allowing through-life and non-destructive monitoring of devices for signs of early deterioration. Results obtained from this work have been very encouraging and have set the scene for further development of the techniques to include degradation fingerprinting and system health monitoring

A wide-band hybrid antenna for use in reverberation chambers

This paper describes the design and performance of a wide-band hybrid antenna suitable for use in reverberation chambers. The antenna is characterised over the frequency range 100 MHz to 25 GHz showing that it performs well above 200 MHz although its ultimate highest operating frequency has not been established

An overview of the European project STRUCTURES

An overview of the European project STRUCTURES and its main challenges is given. Current and foreseen Intentional Electromagnetic Interference (IEMI) threats are classified according to their availability, their technical characteristics (such as bandwidth) and their portability. Critical infrastructures are identified and their most characteristic aspects are highlighted, from an electromagnetic point of view. These concepts are used to establish a set of reference threats to be investigated and possible techniques to handle simulations and measurements in this complex environment are explored, emphasizing the use of the topological approach

Electromagnetic compatibility analysis of unstructured mains networks for high-speed data transmission: Part 2

Different approaches are described for the characterisation of the low voltage mains network that is used for high-speed data transmission broadband over power line (BPL). Part 1 investigated the disturbance scenario of these BPL devices and importance will be given to develop a new measurement procedure in Comite Internationale Special des Perturbations Radioelectrotechnique (CISPR) to estimate the high-frequency characteristics of AC mains networks. The improvements of the measurement method that can also be applied to other wire-based telecommunication systems will also be presented. Part 2 shows the definitions and comparisons of different symmetry factors. The transfer of the results on the compliance test for BPL devices will also be depicted.Electromagnetic compatibility in diffused communications system